For this project i was tasked to make a flange and spigot by following a set of instructions.
I first started by drawing a guide circle and a smaller main circle.
I then created two triangles. The small triangle was a giude so i could get the positioning of the smaller circles correct. And the larger triangle would be extruded to make the base.
I then erased the guide triangle and i used the fillet tool on the larger triangle.
I then extruded the middle circle. And created a smaller circle inside of it.
I then rasied the smaller circle i had previously drawn and used the loft tool. After lofting i used the presspull tool to extend the top face.
I then drew a small circle away from the main model.I then used the extract edges tool to make the rim of the top circle sperate. I then used the sweep tool to make the ring around the model.After that i then used the presspull tool again and then i used the shell tool to make the shape hollow.
